![impulse rc driver fixer tool impulse rc driver fixer tool](https://cdn.shopify.com/s/files/1/1653/0327/files/alien_f2df7927-7644-4559-86ce-074392678a6e_1400x.jpg)
If not, you may have a faulty flight controller. Hopefully by this point you have USB 3, for example, shown at the top of Configurator. If you still don’t see a USB number other than 1, and this is the first time you have plugged a flight controller in to this computer. Sometimes using a USB hub can cause issues. Ideally, you should use a USB port on the front or back of your computer (or side of your laptop). But even decent cables can go bad over time. Some cables are just dodgy from the get-go. The first thing I would check and change is the USB cable it’s self. If only 1 is visible, there is some communications problem. If the number is 1, check the drop down list. Secondly, we can find out which target is installed.Ĭheck the connection box at the top of configurator. Firstly, if we see activity on the flight controllers LEDs, we can see that it’s communicating with our computer, and is working. This is going to allow us to do 2 things. The first thing we are going to do is open up iNav Configurator and plug the USB cable in to our flight controller. There are a few things that we should do before one drop of solder hits our flight controllers. It’s great to plan where you’re going to put things and to test out CG. This article is coming from the perspective of a complete new build. So, once we have our components, we can think about putting it all together. Setting up iNav 4’s continuous servo autotrim.
![impulse rc driver fixer tool impulse rc driver fixer tool](https://i00.psgsm.net/all-spares.com/p/812552/750/Z3X-Box-Samsung-plus-LG-Edition-for-phone-flashing-and-mobile-unlocking.jpg)
Switching to the default layout in a failsafe.The INAV Fixed Wing Group OpenTX models.Setting up non-standard flight controller alignment in iNav 4.Testing the flight controller and finding the target.
Impulse rc driver fixer tool generator#